You can set locked/absolute core for NVIDIA Ampere cards through the paramter --cclk.

--cclk 1200,1300

Will make GPU0 lock core to 1200, while GPU1 will lock core to 1300.

The devices (GPUs) the miner will use. You can use ALL, AMD, NVIDIA or a a comma separated list.

Examples:
--devices AMD
--devices 0,3,4(Will use GPU0, GPU3 and GPU4)

Lets you control how much hashrate for the second coin/algo the miner aims for.

--dualfactor 5,auto,0 will make GPU0 aim for 5x the hashrate of the first algo, GPU1 auto-tune, while GPU2 will disable second algo, and only mine the first algo!

To set a pre-defined target of LHR semiunlock. You can set it to 0 or off to disable.

--lhrtune 76.3,0,77.2

This will make the tuning of GPU0 to aim for 76.3% unlock, disable lhrtune for GPU1 and the GPU2 will aim for 77.2%.

Please notice that the initial tuning still needs to be done, but with specified lhrtune, the semi-unlocker may reach the set value quicker (if possible).

With --lhrwait you can specify a delay before the tuning of LHR starts. Usefull if you are using delayed OC, as the tuning should be done, when the OC have been applied.

--lhrwait 60

Will wait with LHR tuning for 60 seconds.

Adjust how much ETH-speed you can afford to lose, to gain speed on the second algo - normally TON or ALPH. The miner uses a build in tuning progress to optimize the ratio between ETH and the second algo.

Default values are:
Default values used to be:

Ampere	0.5
Turing	4
Pascal	4
RDNA 2	0.75
RDNA	2
Vega	3
Polaris	3

If your rig have 6 gpus, and you want to adjust GPU3 and GPU4 (Fourth and fifth GPU), and disabling second algo (ETH only) on GPU1 (second GPU), you simple add --maxdualimpact *,0,*,4,6,* to your miner options. This will let GPU0, GPU2 and GPU5 run default values, indicated by the *, while GPU3 uses 4% and GPU4 uses 6% possible ETH speed loss. GPU1 will only mine ETH.

Examples with command added:

-a ETHASH -p eu1.ethermine.org:4444 -u 0x222222.WORKER --dualmode TONDUAL --dualuser EQ222222 --dualpool https://next.ton-pool.com --apiport 4444 --tls 0 --watchdogscript reboot.sh --maxdualimpact *,0,*,4,6,*

Locks the memory clock. On core heavy algorithms, this will save power usage!

Controls the amount of information the miner will print in the console, while its work

--silence 0
Default behavior - will show all info.

--silence 1
Turns off "New job"-messages

--silence 2
Turns off "New job"-messages
Turn off "Found shares"-messages, but the * in 15s stats will tell you found/how many shares.

--silence 3
Will only show the "Longstats" (1 minute stats by default)